Home / News

Lyric Robot Ships Complete All-Solid-State Battery Production Line to a Tier-1 Chinese Cell Maker

Date:11-19-2026

Lyric Robot (Li Yuan Heng) has shipped a complete all-solid-state battery production line to a leading domestic battery manufacturer, the company said in November 2026. The line spans front-end electrode preparation, mid-stage cell forming and back-end activation, and is positioned to support both semi-solid volume production and all-solid pilot-to-pre-production runs.

Most solid-state announcements concern materials or cells. Turnkey lines are rarer, because every unit operation has to be redesigned: a solid electrolyte cannot be slurry-cast like a liquid one, and the interface has to be created mechanically.

Equipment in the line

  • Solvent-free double-sided coater: builds a self-supporting dry electrode film, cutting solvent consumption by 11.5% and energy use by 46% versus the wet route
  • Roll-press and thermal-lamination combi unit: combines electrode compaction with electrolyte transfer lamination to control interfacial uniformity
  • Frame molding machine: micron-level edge control to prevent edge short circuits, a known failure mode in solid cells
  • Isostatic press: Pascal-principle isotropic densification to reduce interfacial porosity and contact resistance
  • High-pressure formation and grading: up to 150 tonnes of constraint pressure with over a hundred safety interlocks
  • Material compatibility: sulfide, oxide and halide electrolyte systems; sulfide lines include H2S monitoring and sealed negative-pressure enclosure

Why it matters

The dry electrode route is the strategically important element. Solvent recovery is one of the largest cost and footprint items in a conventional lithium-ion plant; removing the solvent step shrinks the factory, the energy bill and the environmental permitting burden at the same time. If solid-state cells are to reach cost parity, dry processing is widely regarded as necessary rather than optional.

The 150-tonne formation press illustrates why solid-state equipment is a different business from liquid-cell equipment. Conventional formation fixtures apply modest stack pressure; sulfide and oxide cells need sustained high constraint to keep interfaces in contact through volume change.

What is not yet proven

Line throughput, takt time, yield and cell performance after ramp are not public. "Shipped" means installed and commissioning, not qualified. The economics also depend on electrolyte membrane cost, which is outside the equipment vendor's control. No customer name was disclosed.

Source

Reported by China Battery Enterprise Alliance (cbea.com), November 2026. Chinese-language sources only.

Prev: Atomrobot Unveils Tianqiao No.1 Tendon-Driven Dexterous Hand With ±0.1 mm Repeatability

Next: Lead Intelligent Launches 600 MPa Warm Isostatic Press for Solid-State Batteries