Atomrobot released the Tianqiao No.1 (Tianqiao-1) bionic five-finger dexterous hand on 5 November 2026, using a tendon-driven flexible transmission scheme with a rear-mounted drive unit and repeat positioning accuracy of plus or minus 0.1 mm.
The hand is the component that most directly limits what a humanoid or collaborative robot can actually do. Conventional approaches put motors in the palm or forearm, which adds mass at the end of the arm and forces the wrist to carry it. Tendon routing moves the actuators back into the forearm or torso and transmits force through cables, trading stiffness for weight and compliance.
Dexterous hands are becoming a volume component category as humanoid programmes move from demonstration to pilot deployment. The design trade-off is explicit: tendon drive gives a human-sized hand with human-like compliance, but cable stretch, friction and wear make repeatability harder to hold than with a rigid linkage. Publishing plus or minus 0.1 mm is therefore a claim about cable tension control and calibration, not just mechanical design.
Domestic supply of high-precision hands matters for cost. A humanoid with two hands at imported prices can carry a five-figure dollar bill for end effectors alone, which is untenable for the service and light-industrial price points Chinese vendors are targeting.
Payload per finger, grip force, cycle life of the tendon system and tactile sensing capability are not disclosed. Repeatability measured unloaded tells little about performance under grasp load, which is where cable compliance shows up. There is no independent test data and no announced customer.
Reported in GGII and industry roundups of November 2026 product launches. Chinese-language sources only.